When you are creating Property Lines for your site in your
model, the default out of the box settings for the Property Line creation can
be a little confusing, especially if you are creating them by entering distances
and bearings.
The table you are greeted with will only let you enter
bearing distances between 0°
and 90°,
as its forms the Property Lines using compass quadrant points and locates the
lines in each quadrant….it is a little confusing, but there is an easier way to
enter this information. (Even explaining it is a little confusing!)
If you select the little arrow besides the Model Site
heading, you will be taken into the Site Settings dialog box. Change the Angle
Display setting to Degrees.
This will alter the Property Lines dialog box, so that the
method for entering the data will just use the distance and bearing, and not
the quadrant method.
nice i was getting crazy thanks
ReplyDelete